| TOP
> Cutting Tool> Solid Carbide Endmill |
|
|
END MILLS
|
| |
| Suitable for Mold Industries |
|
■MET230 Mugen-Coating 2-Flute Taper End Mill
|
|
|
|
|
・Our original MUGEN COATING has been put on 2-flute taper End Mill.
・The Tool life is longerat taper cutting.
・The dia. sizes are available 0.2 to 10 and the single angles are from 30 to 20°(less than
dia. 6.0)
|
|
■MSE230 Mugen-Coating 2-Flute Taper End Mill
|
|
|
|
|
・It can be had all-round cutting from roughing to finishing.
|
|
■MSB230 Mugen-Coating 2-Flute Ball End Mill
|
|
|
|
|
・It is very suitable for precision three dimentional cutting in the low to high speed area.
|
|
|
■MSE430 Mugen-Coating 4-Flute End Mill
|
|
|
|
|
・Our original MUGEN-COATING has been put on 4-Flute End Mill.
・It can be cut from non-hardened materials to hardend materials.
|
